About
Technical Guides
Touchpad Setup
Active LXR Touchpad Buttons
Hover over the Active LXR Touchpad™ to see where the buttons are pressed. Press the Set/Power Button to begin an LXR session after programming its settings. You can also manually adjust the temperature to raise or lower the intensity of the session to match your comfort level throughout the session.
Clock
Setting Up the Clock
Step 1: Press the area indicated and the Hour will blink on the screen.
Step 2: Use the Session Time Left and Right arrows to adjust to the correct time. Press the Set/Power button to enter, then the Minutes will blink.
Step 3: Use Step 2 to complete the Clock setup.
Session Time
Setting Up the Session Time
Step 1: Press the area indicated and the Session Minutes will blink on the screen.
Step 2: Use the Temperature Left and Right arrows to adjust to the correct time. Press the Set/Power button to enter
Temperature
Adjusting the Temperature
Press either areas indicated and the Temperature will blink on the screen.
Use the Temperature Left and Right arrows to adjust to the desired degrees anywhere from 108°F to 160°F. Press the Set/Power button to enter.
Features
Relaying Display
The Active LXR Touchpad screen will relay between the Clock, Session Time left, Heater Output Temperature, and Room Temperature.
Did You Know?
A sensor is located above the Touchpad to measure the LXR's room temperature. It's placed there to show you that Pure Far Infrared doesn't heat up the air (i.e. convection heat, near infrared, medium infrared) but rather your body directly. So you'll see with proof each time that real Far Infrared takes a long time to heat the room up, while it goes to work right away on your body.
Interior Lamp
Press the Light button at anytime for your convenience.
Automatic Shutdown
The LXR will turn itself off into Standby Mode once the Session Time goes to zero.
Hints & Tips
Session Memorizer
The Active LXR Touchpad will turn on to the same settings as its most recent session. Just press the Set/Power button once for your next session and it'll be ready to use in just 5 minutes.
Hold the Button Down
The Active LXR Touchpad responds to a gentle touch to the selective areas. If you're having difficulty setting the control, try pressing the area down for 1 second. Hover over the Touchpad Buttons picture above to see what areas of the Session Time, Temperature, Light, and Set/Power buttons are active.
Your First Session
If it's your first time using the LXR, try the session at 15 minutes with temperatures between 108°F to 120°F to see how your body responds.